Tundra Remote Door Lock Reprogram

Repeat button procedure to program remaining remote transmitters.

Tundra remote door lock reprogram.

You must complete these operations within 40 seconds. If the door locks cycle twice repeat steps a and b in step 6 as the remote was not accepted. The locks should cycle once to verify that the car has accepted your remote. This is the best and easiest fix.

Each set represents one pass. Press and release lock or unlock button. Press and hold lock and unlock button for 1 5 seconds. Within 3 seconds the door locks should lock and then unlock once indicating successful programming.

System should now lock and unlock vehicle once to confirm registration twice to indicate registration has failed. Insert your key into the ignition switch and put it in the run position. While there is the possibility of a pretty big electrical issue most of the problems are minor and easy to fix. Close the driver s door.

Once your car is in programming mode with the remote you are trying to program press the unlock and lock buttons simultaneously for about 2 seconds then release and press just the lock button for 1 second. Press the lock button by itself and hold for 2 seconds. If you have done everything correctly within three seconds the door locks should lock then unlock automatically. Using the door control pad located on the driver s side door press the lock and unlock buttons once again for five passes.

Turn the ignition to on and then back to off and remove the key from the ignition. Repeat steps a and b in step 6 for each new remote. If you key fob no longer unlocks the doors it is time for a new battery.